Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VMS 2.1 Reporting

The "canned" reports from the VMS 2.1 security monitor seem to be geared towards IDS reporting. I have a VPN concentrator, Host IDS agents, a Dial up 3600 series router, and a 515R PIX that are all sending syslog or "defautt" alerts to the VMS machine. The section under generating reports where you specify different parameters (source IP destination IP, devices, etc) all seemed to effect only the network IDS. What options do I have to report on any of the Host IDS agents, the PIX or other devices. I have tried to put their IP addresses in as the source, but again the report parameters seem to be IDS specific? Please advise and thanks for any input.

1 REPLY
Bronze

Re: VMS 2.1 Reporting

The following doc says that along with VMS 2.1, in built comes a monitoring centre which will take care of what you are trying to do

http://www.cisco.com/en/US/products/sw/cscowork/ps3991/products_qanda_item09186a00800e55bc.shtml

Might be worth tyring to enabling this feature

91
Views
0
Helpful
1
Replies
CreatePlease login to create content