Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vpdn commands in 7.0 asa

hows the going lads,

We are about to purchase a new ASA 5505 but it will be behind a netopia DSL router . The netopia will be put into bridge mode and the vpdn configuration will be applied to the ASA.

However I have read that the VPDN commands has been replaced in 7.0 so my question is how do I go about connecting back across PPPOE without the VPDN command .

Any help is really appreciated.

Thanks.

3 REPLIES
Silver

Re: vpdn commands in 7.0 asa

As you have a ASA-5505, you must be running 7.2 code or later. PPPoE configuration was reintroduced in this version. Here is a link which explains how to configure ASA as a PPPoE client-

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008066ebe6.html

Hope that helps.

Regards,

Vibhor.

New Member

Re: vpdn commands in 7.0 asa

thanks Vibhor,

You're right it has been reintroduced thank god for that.

Kevin

New Member

Re: vpdn commands in 7.0 asa

Note: PPPoE is not supported when failover is configured on the security appliance, or in multiple context or transparent mode. PPPoE is only supported in single, routed mode, without failover.

116
Views
0
Helpful
3
Replies