Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPN 3000 - configuration of Private and Public interfaces

Trying to set up the 3000 Concentrator re 3.5!

I can configure the Private interface ok, giving it an ip number - but as soon as I configure the Public one (an ip number belonging to the same network) the Private IP stops responding (I can't even get into the manager via a browser). However, when I physically unplug and plug the cable back in it starts responding again, but the Public one goes down.

Is this because the IP numbers are on the same network?

Help....thank you

1 REPLY
New Member

Re: VPN 3000 - configuration of Private and Public interfaces

The interfaces should be on different subnets. Put your private interface on a private subnet.

78
Views
0
Helpful
1
Replies
CreatePlease to create content