I keep getting err msge "bad ip address/subnet mask/wildcard mask/area id" when trying to add a class C network to the list on a VPN 3000 concentrator using the CLI. Here's my entry 192.168.51.0/0.0.0.255. Both the number and wildcard mask seem ok. Isn't that the correct syntax?
Syntax is correct on whichever wildcard mask you want to use,however,when you are prompted to add a network wildcard information enter 192.168.51.0 firs then enter to proceed to wildcard mask info, you will be prompted to enter wildcard mask then place your 0.0.0.255 wildcard mask,you cannot place 192.168.51.0/ 0.0.0.255 on first network field.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...