Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN 3002

I have set up a vpn 3002 to connect to our 3015 concentrator. The 3002 is doing Pat. My question is When I disconnect manually from the hardware client either from unplugging power or I disonnnect the tunnel, the tunnel does not reconnect by itself. Is this a normal behaviour. I have to login to the client go to IPsec and click connect to get the tunnel up again.

1 REPLY
Bronze

Re: VPN 3002

In PAT mode, a tunnel is initiated in two ways

- when data passes to the VPN Concentrator

- when Connect Now is clicked.

After disconnection, one of the above needs to happen to re-establich connection.

Automatic establishment of the tunnel happens in Network Extension mode.

88
Views
0
Helpful
1
Replies
CreatePlease to create content