Ive the following network configuration: 2 ISP Router, 2 VPN concentrators 30xx and 2 edge router to my LAN. From the WAN side (Remote offices) there are VPN tunnels realized with PIXs in every remote office.
I created a redundant configuration with VRRP. The first step was the activation of VRRP on all twin devices (WAN router, VPN, LAN router). This configuration works well and problem less. Now I got a lot more of remote offices and therefore a lot more traffic. My plan was to share the traffic between the both paths (like a fixed load balancing). Each twin device will be configured to support two virtual routers (VRID) I know this solution from Cisco Routers and Nokia FW devices (also described in RFC2338 - point 4.2).
Now to my prob: Is there a way to configure the VPN concentrator 30xx to handle two different virtual routers? With my doings I got just one virtual router up. Any tips for this configuration or any other suggestion (other design or methods) to solve this problem?
Since there has been no response to your post, it appears to be either too complex for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml
If anyone else in the forum has some advice, please reply to this thread.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR
and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity
options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in
HA DocumentationCode download linksGoalRequirementLimitationsSupported
ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationCo...
Question I am currently unable to specify "crypto keyring" command when
configuring VPN connection on my cisco 2901 router. The following
licenses have been activated on my router :