Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPN 5008 to 3015 - issues with tunnels resetting

Has anyone run across tunnels having to be reset when using a 5008 and a 3015. Are there SA lifetime settings or some other tuning that can be done on either side to prevent a tunnel from going down?

We are having to reset the 5008 to PIX tunnels every day due to SA lifetime problems. We are not nec. seeing the same issue with the 5008 to 3015's but not ruling it out.

We did not capture the far error messages around this yet. I thought I'd ask in case someone has seen problems of this sort between 5008s and 3015s.

thanks for your help

-tms

1 REPLY

Re: VPN 5008 to 3015 - issues with tunnels resetting

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

119
Views
0
Helpful
1
Replies
CreatePlease to create content