Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN and GLBP!!!

Hi,

Does any body know when the "GLBP redundancy client" will be released?

Is it possible to configure VPN(site-to-site) and GLBP in same interface in Cisco router?

Is there any special commands or setup to look for?

Both GLBP and VPN is in WAN part.

2 REPLIES
Silver

Re: VPN and GLBP!!!

(router-if)#glbp group name redundancy-name

Enables IP redundancy by assigning a name to the GLBP group.

The GLBP redundancy client must be configured with the same GLBP group name so the redundancy client and the GLBP group can be connected.

Community Member

Re: VPN and GLBP!!!

I didnt get. Can you please give more details.

My router commands for GLBP is below:

TestC(config-if)#glbp ?

<0-1023> Group number

TestC(config-if)#glbp 10 ?

authentication Authentication method

forwarder Forwarder configuration

ip Enable group and set virtual IP address

load-balancing Load balancing method

name Redundancy name

preempt Overthrow lower priority designated routers

priority Priority level

timers Adjust GLBP timers

weighting Gateway weighting and tracking

TestC(config-if)#glbp 10 name ?

WORD Name string

TestC(config-if)#glbp 10 name load

TestC(config-if)#

>>>The GLBP redundancy client must be configured with the same GLBP group name so the redundancy client and the GLBP group can be connected.

How to configure the GLBP redundancy client?

132
Views
3
Helpful
2
Replies
CreatePlease to create content