Yes correct answer on the DNS, but I realize the problem is not with my network drives internally. It is drives from my own network environment from home and I can assume others agencies who would connect in have the same issues.
I am also having this exact same problem. With the regular Cisco VPN client, no issues. With AnyConnect, I have to disconnect the drives and re-run the login script manually every time I connect. I can map via name or IP address and it works just fine, taking DNS issues out of the mix, but any "remembered" drive mappings are hosed with AnyConnect. If I disable the remembering of drive mappings, then users have to manually run the login script every time they connect regardless, so not a very good solution there, either. Would be helpful if there was some additional functionality to kick off a script after successful connection.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...