Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN client 3.6.2 to remote domain

I am using client version 3.6.2 to a pix 520 running 6.2.2. I loaded the client to my home pc (XP prof.) which is behind a linksys router. The Client installed and when I run the client I can ping anything in the range I setup the PIX for. I also can map a drive to a remote NT server and see everything I hoped for. But I cannot browse the network. What am I doing wrong???

1.) I have file and print sharing enabled.

2.) In the client I have Allow Local Lan acces enabled, But after I connect the status screen of the client says I do not have it enabled.

3.) I also have Enable transparent tunneling checked of using UDP.

Any help ???

2 REPLIES
New Member

Re: VPN client 3.6.2 to remote domain

What info are you feeding your client when you connect? DNS or WINS info will probably help here, depending on how your network currently browses.

New Member

Re: VPN client 3.6.2 to remote domain

I did not specify a WINS server because we curently do not use one. When I speciifed the DNS IP it was the one from ISP we use? Do you think it would help the browsing to setup a WINS server? Inside our private network we have never needed one.

Thanks

116
Views
0
Helpful
2
Replies
CreatePlease login to create content