Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN Client 3.6.3.B

Hi,

I am not able to find the release notes for this version. Does anyone know what has been fixed?

Also, is this the recommended version to run or should we use version 3.6.3 (which has release notes on CCO) instead?

Regards,

Harald

1 REPLY
Cisco Employee

Re: VPN Client 3.6.3.B

3.6.3B is recommended, no problem there. The release notes were sent to the CCO people at the same time as the client software, but for some reason they went missing, we're working on getting them re-posted. For the time being, here's what they contain:

The following bugs have been resolved in Release 3.6.3.B

Revision: Release 3.6.3.B

Files: vpnclient-win-is-3.6.3.B-k9.exe

vpnclient-win-msi-3.6.3.B-k9.exe

Contents:

CSCdy50212 - Routing problems when using Non-English version of Windows 2000

CSCdz41646 - Req: Show DN of certificate being used during connection establishment

CSCdw61796 - Certificate Validation failure events need more detail

CSCdv43347 - Client should display error on Connection Status if cert not found

CSCdz23365 - MSGINA.DLL not used as incompatiblegina when specified

CSCdz61884 - tunnel indicator in W2k registry not reset when tunnel terminated

CSCdy81064 - Adapter IP changed event needs to identify IP addresses

CSCdz56951 - Mobile GPRS dial-up...VPN wait time before tunnel establishment

CSCdx54679 - Client should notify Novell (if installed) after connection

CSCdz62411 - VPN client does not show disconnected after 3000 initiated disconnect

CSCdz72657 - XAuth process takes too long to create

CSCdz26371 - Client NAT-T payloads makes concentrator think its behind a NAT box

New Feature: VPN Client XAuth with Radius SDI (EDCS-253192)

Connection Entry profiles now can have a flag "RadiusSDI" to enable better handling of Radius SDI XAuth requests. If the flag is zero, then everything works the same as before. If the flag is one, then the client assumes Radius SDI is being used for XAuth. The default value is zero. Refer to EDCS-253192 for more information, including descriptions of some new vpnclient.ini parameters.

In addition, a connection entry profile can also have a flag "SDIUseHardwareToken" to instruct the client to ignore the presence of RSA SoftID software. If this flag is zero, then everything works the same as always. If the flag is one, then the client will ignore RSA SoftID software installed on the machine. The default value is zero.

110
Views
0
Helpful
1
Replies