Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN Client 3.6 to PIX, tunnel comes up but...............

I am trying to configure a PIX to terminate a VPN tunnel from a remote PC with VPN Client 3.6. I am able to get the tunnel up, but cannot ping anything on the internal network. Any suggestions would be appreciated.

Thanks!

  • Other Security Subjects
2 REPLIES

Re: VPN Client 3.6 to PIX, tunnel comes up but...............

Did you check the routing for the IP pool that you used ?? if not check the routing for the IP pool and point the route to the firewall . Also check the access-lists .

New Member

Re: VPN Client 3.6 to PIX, tunnel comes up but...............

Not exactly sure what you mean. The remote client is receiving an IP address from the pool.

Thanks.

92
Views
0
Helpful
2
Replies
This widget could not be displayed.