I know that we could configure the vpn client for autoinitation on WLAN by configuring the client to watch for an IP binding to a specific IP address range. Is it possible to configure the client to watch for a specific dial-up connection?
We have a dial-up connection that is called up from a specific application. When user specifies a synchronize, it will automatically dial a predetermined connection. However, to terminate the connection, a VPN has to be initiated. We would like the VPN to automatically load when a specific dial-up connection is active. Is it possible?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...