Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN client drop

I've set up a PIX to be used with the Cisco VPN client. Everything works fine. However, if I try connecting to the PIX with a second computer at the same remote site, it knocks off the first connection. Is it possible to connect multiple users to a pix from the same site using the VPN client? If so, how?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: VPN client drop

PIX Firewall Version 6.3 provides a feature called "Nat Traversal". NAT Traversal allows ESP packets to pass through one or more NAT devices. This feature is disabled by default.

To enable NAT traversal, enter the following command:

isakmp nat-traversal [natkeepalive]

Valid values for nat keepalive are 10 to 3600 seconds - the default is 20 seconds.

1 REPLY
Cisco Employee

Re: VPN client drop

PIX Firewall Version 6.3 provides a feature called "Nat Traversal". NAT Traversal allows ESP packets to pass through one or more NAT devices. This feature is disabled by default.

To enable NAT traversal, enter the following command:

isakmp nat-traversal [natkeepalive]

Valid values for nat keepalive are 10 to 3600 seconds - the default is 20 seconds.

99
Views
0
Helpful
1
Replies
CreatePlease to create content