Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN-Client / lost IP-binding on NIC

Hi,

after Installation of the VPN-Client 1.1, the binding of the IP-protocol at the embedded nic is lost. I can bind a new IP-protocol at the nic, but after restart, the binding is again lost. After uninstall of the VPN-Client, the IP-binding at the nic is OK. The IPSec-Tunnel over the Dial-Up-Network works everytime OK. Have you any suggestions ?

Thanks a lot,

Frank

2 REPLIES
Bronze

Re: VPN-Client / lost IP-binding on NIC

I had the same problem not that long ago. I had to completely remove the NIC, Setup the VPN client for dial, then reinstall the NIC physically and setup my IP stack for it. Kind of a pain but it worked.

Community Member

Re: VPN-Client / lost IP-binding on NIC

Thanks. I'll try it.

Frank

206
Views
0
Helpful
2
Replies
CreatePlease to create content