Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN Client <-> PIX515e Tunnel dropping

Hi,

I'm using a Pix515e 6.3(1) and VPNClient V4.0.1 to remote access

for users. I'm getting some users reporting that the "connection stops

working after a while" and they have to re-establish the connection.

I'm got a trace/log from the VPNClient (see below).

It's not an inactivity timer or connection duration timer on the PIX,

so I wondered if anyone else has seen this.

Many Thanks,

Cisco Systems VPN Client Version 4.0.1 (Rel)

Copyright (C) 1998-2003 Cisco Systems, Inc. All Rights Reserved.

Client Type(s): Windows, WinNT

Running on: 5.0.2195

1 12:31:30.145 06/26/03 Sev=Info/4 CM/0x63100013

Phase 1 SA deleted cause by DEL_REASON_PEER_NOT_RESPONDING. 0 Phase 1 SA currently in the system

2 12:31:30.145 06/26/03 Sev=Info/5 CM/0x63100025

Initializing CVPNDrv

3 12:31:30.145 06/26/03 Sev=Info/6 CM/0x63100031

Tunnel to headend device 195.224.169.98 disconnected: duration: 0 days 2:49:5

4 12:31:30.155 06/26/03 Sev=Info/6 CM/0x63100037

The routing table was returned to orginal state prior to Virtual Adapter

5 12:31:30.876 06/26/03 Sev=Info/4 CM/0x63100035

The Virtual Adapter was disabled

1 REPLY
New Member

Re: VPN Client <-> PIX515e Tunnel dropping

Maybe your client router or modem cable cannot handle fragmentation .

You may try to adjust the MTU on the client side .

Start - Programs- Cisco....-Set MTU

The default value is 1300 , you can lower it until you reach a value wich

always work .

94
Views
0
Helpful
1
Replies
CreatePlease login to create content