Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN Client to IOS-Can get to internal dynamic IPs but not static NATs

I have an issue where I can VPN client to IOS router 12.2.15T and everything works with the exception of the Statically assigned NAT'ed servers. Unless I remove the NAT assignment, I cannot access the server. Any ideas here?

thanks

Aaron

1 REPLY
New Member

Re: VPN Client to IOS-Can get to internal dynamic IPs but not st

The Static NAT's always exist. Meaning that you have to do policy routing to make the router think the traffic is not coming from the "ip nat inside" interface going to the "ip nat outside" interface. Basically you route the traffic out a loopback interface and it comes right back in then out thru the VPN without being NAT'd.

Take a look at this, it will resolve your problem:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094634.shtml

Regards,

102
Views
0
Helpful
1
Replies
CreatePlease login to create content