It seems that you are permitting the access-list 101 to go through and get NAtted. Is that what you want to achieve? The following should provide the help you need to get NAT and IPSec work together here hand in hand:
I'm still unsure on the configuration changes. I have pasted the whole configuration below to make it easier to help. I can connect to the router successfully using the cisco client, but can only contact devices that aren't specified on access-list 101 - I believe this is because the NAT is being used on these address. How can I still use NAT, but still contact the devices on access-list 101. Please help me with what changes I need,
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...