Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN conncetion via PIX 501

Hello,

I got a problem with a Cisco PIX 501.

The network equipment changed (Modem) and also the IP Addresses.

I changed the IP Addresses on the PIX and on our concentrator where the vpn tunnel will be terminated.

So the modem/router is configured with 2 offical IP Addresses - one on the outside and one on the inside connection.

he pix also got an offical IP Address from the same network.

Internet is working - I can ping from the pix to any offical IP?s.

When the pix tries to establish the vpn connection, I got this error message on the concentrator:

13180 02/02/2007 14:05:09.620 SEV=4 IKEDBG/65 RPT=22091 <IP OF THE PIX>

IKE MM Initiator FSM error history (struct &0x3badffc)

<state>, <event>:

MM_DONE, EV_ERROR

MM_WAIT_MSG2, EV_RETRY

MM_WAIT_MSG2, EV_TIMEOUT

MM_WAIT_MSG2, NullEvent

What can be the problem ?

I?ll try to reach the pix via telnet and I will then post the output of crypto ipsec

Best regards

Kai

1 REPLY
Cisco Employee

Re: VPN conncetion via PIX 501

Kai,

Complete debugs/config from the concentrator the PIX would be a start in the right direction

deb cry isa

deb cry ipsec

Thanks

Gilbert

116
Views
0
Helpful
1
Replies
CreatePlease login to create content