VPN connection established but cannot access anything on local LAN
I've used SDM to configure EasyVPN on Dialer1 interface of my Cisco C1760. Cisco VPN Client Software can connect to the router, get ip address but I cannot ping or access any servers in the local lan (192.168.0.0/24). After the VPN connection is established, I test by trying to telnet to 192.168.0.1 (vlan1 interface) which is the router itself but it doesn't work.
Please help me figure this out. Please see the attachment on this post for running-config and everything else.
Re: VPN connection established but cannot access anything on loc
Refer to Remote Access and EZVPN Users Connect to VPN and Have No Other Access to Resources section of the document Most Common L2L and Remote Access IPSec VPN Troubleshooting Solutions for more information
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...