Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN Connects - No traffice passes

Using a Pix 500 series with v 7.1 of the software.

Normally clients connect with no problems.

I have a few clients that happen to use the same IP network for there local lan, as one of our internal lan's that the VPN allows access to.

IE the client (before connecting to the VPN) uses 10.1.1.0 255.255.255.0.

One of our primary server networks happens to use the same network.

When connected to the VPN a 172.16.x.x address is assigned to the client as connected to the tunnel.

The connection works fine, but no traffic ever hits the fw. I have tried removing split tunnels, and have tried enabling hairpinning and what not.

I guess my first question is whether or not this is even a possible (functional) configuration.

1 REPLY
New Member

Re: VPN Connects - No traffice passes

yes, I have done it, but to make it work you must do "route print" AFTER the VPN connects and if the output shows local route to the same net number you must delete it by doing route del xxxx forgto the exact syntax.

Of course this is not useful as next time you reboot the same procedure must be followed. My take - chage net numbering :)

100
Views
0
Helpful
1
Replies