Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

bma
New Member

vpn dynamic-map

Hi

I am using pix515, cisco vpn client 1.1 for VPN users. Some users get connetion slow problem, about to ping several times, then can make tunnel ok. From vpn clinet 1.1 log view, can get phase 2 time out message when it has problem. is it dynamic-map problem? if use static map, can it be fixed? or depends on internet traffic?

Thanks

ben

1 REPLY

Re: vpn dynamic-map

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

86
Views
0
Helpful
1
Replies