Hi
I was wondering if anyone could help point me in the right direction with the following problem.
I have been trying to connect to several companies (that I support) VPN's from home. They have the same devices as me. Which is a Pix 501 firewall which is behind a Cisco 827 ADSL router.
I only have a single public IP which is on the Router, and the Router is performing NAT. The Pix is not performing any NAT. I have allowed all TCP, UDP and IP protocols out of my firewall. And I have allowed only, ESP,ISAKMP and pc-anywhere DATA and STATUS back in. As I want to be able to use Pc-anywhere to control the servers.
The problem I have is that I can talk to the remote PIX using the Cisco VPN client and it establishes the VPN tunnel. I get an IP address for the VPN client but I cannot connect to the server.
I have done some debugs on the Router and can see that the router is sending packets to the destination firewall but not getting a reply. I can also see that the VPN client is encrypting packets. But I get no replies.
Also if I dial up to my ISP direct using a Modem and I connect to my clients VPN I can see the server and use Pc-Anywhere. Its just a problem if I go through my PIX and Router.
Is what I am trying to do possible? Any suggestions would be greatfully appricated.
TIA
Dave