I can VPN into our remote router, but unable to access any internal devices in the remote network. I am unable to ping any interfaces off the router. the outside ip is pingable. When directly connected to the remote router, I can ping and access everything in the internal network. Any suggestions.
> NAT-Traversal or NAT-T allows VPN traffic to pass through NAT or PAT devices, such as a Linksys SOHO router. If NAT-T is not enabled, VPN Client users often appear to connect to the PIX or ASA without a problem, but they are unable to access the internal network behind the security appliance.
Note: With IOS 12.2(13)T and later, NAT-T is enabled by default in IOS.
So, If you have an IOS lower than 12.2(13) try to enable the command or upgrade your IOS version.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...