Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN Multipoint

Hi guys,

I have a little problem my VPN configuration. I have 4 sites, one is the headquaters and the others are the remote sites.

So, I try to make 3 site-to-site VPN connections, one for each remote sites. I have 7120 cisco router on the HQ and three 1760 cisco routers on the agencies

I configure my 7120 router for one site and it's ok. But, when I try to configure the second site, I can enter all the commands but I receive no data when I try to ping the remote server.

The "sh int tun 1" command said that the tunnel is up, line protocol is up, hardware is tunnel..." but I have no packets received.

firstable, I want to know if is it possible for a Cisco router 7120 to manage several VPN tunnels?

If yes, can you tell me what command I did forget in configuring my router?

I need your help to resolve my problem.

Thanks in advance

1 REPLY
Bronze

Re: VPN Multipoint

I did see a few bugs related to Multipoint VPN's but most of them were relevant to a setup when NHRP was configured too, which does not seem to be the case in your setup. The other possibility is a configuration problem. A couple of documents on configuring dynamic multipoint vpn are available on the IPSec support page at http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Internetworking:IPSec&s=Implementation_and_Configuration. You could also refer to http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080110ba1.html

97
Views
1
Helpful
1
Replies
CreatePlease to create content