Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN on PIX to client

I am trying to build remote client VPN's on a PIX running 6.3.3 code. The client get's an address, but no gateway, and is not able to get around the inside interface network on the PIX. Is this a NAT issue, a gateway issue, or a routing issue?

1 REPLY
Cisco Employee

Re: VPN on PIX to client

Hi,

Are you able to ping the inside interface of the PIX? For confirmation, please enter the command 'man i' in the config mode on the PIX and then ping the inside interface of the PIX from the client. If this works, then please check the following :

1. nat (inside) 0 configuration.

2. Access-list on the inside interface.

3. Default gateway in the inside hosts.

If you are not able to ping the inside interface then you might need 'isakmp nat-t' command on the PIX.

HTH,

Please rate if it helps.

Regards,

Kamal

93
Views
0
Helpful
1
Replies
CreatePlease login to create content