Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

VPN pass-through problems

I have a 2611 running 12.1(19). I have cust. on the LAN side trying to VPN out to other places on the internet. They all have public IP's. Some of them are not able to VPN through our network, but if they dialup they can. Is there something I need to add or enable in order for them to VPN though my router. We are not doing anything special except multilink. Other than that pretty standard setup.

1 REPLY
New Member

Re: VPN pass-through problems

Hi Cody

You may have to think about allowing IPSEC traffic back in through your router port 500/50/51 traffic - if the clients are using IPSEC based VPNs - if they are using other VPNs such as PPTP or L2TP then adjust your access lists accordingly.

Hope that gives you a start

Steve

101
Views
0
Helpful
1
Replies
CreatePlease to create content