Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN Passtrough?

Hello.. I've reading a method here to passtrough VPN traffic from the inside to an external VPN, however, i have a 7.0(4) version installed and it does not accept me the command "fixup esp-ike". It's not supported. How can i do this ?

I'll really appreciate any help

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: VPN Passtrough?

in 7.x the fixup commands were replaced by inspect commands. Look here for the configurations:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/inspect.htm

Look here for VPN NAT-T and such:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/ike.htm#wp1052899

2 REPLIES
Community Member

Re: VPN Passtrough?

in 7.x the fixup commands were replaced by inspect commands. Look here for the configurations:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/inspect.htm

Look here for VPN NAT-T and such:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/ike.htm#wp1052899

Community Member

Re: VPN Passtrough?

Thanks for reply, however i couldn't fix the problem, what i did was to apply an access-list, then i nat it. This access list contains a tcp permit host and a UDP permit host.. with that applied worked fine.

Thanks.. best regards.

195
Views
0
Helpful
2
Replies
CreatePlease to create content