VPN router and firewall

[yong510]

Dear all,

Is it posible that i install a Software VPN in Cisco 2600 that connect to Internet and put it in front of a firewall ?

I try to use Secure VPN Client to connect to the router, it can create a tunnel successfully. my problem is client can not access the Internal server which is located behide the firewall. the two Interface of the router is using public IP and the outside Interface of firewall is using public IP as well.

Please give some advice.

[ashraf.ali]

Yong,

This is absolutely possible. All you gotto do is Configure the IPSec client to allow traffic to the private IP addresses of the servers which would be routed accross the Firewall. If you have NATed the servers inside the global IP address of that servers needs to be routed across the VPN tunnel.