Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPN Secure Remote Client1.1

Remote user dial the internet and get a dynamic routeable IP and reaches one of my Secure tunnel gateway. The secure tunnel gateway in tern have meshed tunnel(IPSec) between three location. The Secure remote client would like to reach the servers in other regions by establishing the tunnel with single region. Now router is configured with wild card with no mode config. Is it possible to give static IP(Private nonroutable IP) in the client configuration and make the remote user to reach the servers in other region

1 REPLY
New Member

Re: VPN Secure Remote Client1.1

With mode Config you can assign your user a routable pool address that once the tunnel is built will allow him/her to access the entire internal network.

Check this out:

http://www.cisco.com/warp/public/707/25.html

309
Views
0
Helpful
1
Replies
CreatePlease to create content