cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
416
Views
0
Helpful
4
Replies

VPN Setup on Pix 515e

njamabraasch
Level 1
Level 1

Hello - I have a pix 515 that I am trying to enable VPN for. I went through the VPN wizard, choosing the options

Remote access

outside interface

PPTP

MSCHAP

Local VPDN - I set up a user

my Pool is 192.168.1.0-192.168.1.100 (inside network is 192.168.0.X)

I am pushing the dns server IP for the pix to the clients

I am leaving address translation exemption blank.

I can connect from outside the network, I just can't see the inside network.

What am I missing here?

I can post the running configuration if that would help.

4 Replies 4

acomiskey
Level 10
Level 10

isakmp nat-traversal

Just a guess with limited information, if not post your config.

Thanks for the response!

Is that a line in my config that I need to add? so far I've done some limited manual config changes, but I mostly work through the PDM. Can you elaborate?

Yes it is. Not sure where it is in PDM, somewhere in the vpn options, but is probably a check box that says something about allowing inbound ipsec sessions to bypass interface access lists. Is this pix 6 or version 7? Oops, skimmed through too fast, you're doing pptp, don't think that will work. Post a clean config.

I attached the pre and post vpn configs. Let me know if you see anything missing.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: