Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

VPN Setup on Pix 515e

Hello - I have a pix 515 that I am trying to enable VPN for. I went through the VPN wizard, choosing the options

Remote access

outside interface

PPTP

MSCHAP

Local VPDN - I set up a user

my Pool is 192.168.1.0-192.168.1.100 (inside network is 192.168.0.X)

I am pushing the dns server IP for the pix to the clients

I am leaving address translation exemption blank.

I can connect from outside the network, I just can't see the inside network.

What am I missing here?

I can post the running configuration if that would help.

4 REPLIES
Green

Re: VPN Setup on Pix 515e

isakmp nat-traversal

Just a guess with limited information, if not post your config.

Community Member

Re: VPN Setup on Pix 515e

Thanks for the response!

Is that a line in my config that I need to add? so far I've done some limited manual config changes, but I mostly work through the PDM. Can you elaborate?

Green

Re: VPN Setup on Pix 515e

Yes it is. Not sure where it is in PDM, somewhere in the vpn options, but is probably a check box that says something about allowing inbound ipsec sessions to bypass interface access lists. Is this pix 6 or version 7? Oops, skimmed through too fast, you're doing pptp, don't think that will work. Post a clean config.

Community Member

Re: VPN Setup on Pix 515e

I attached the pre and post vpn configs. Let me know if you see anything missing.

96
Views
0
Helpful
4
Replies
CreatePlease to create content