VPN Site-to-Site between PIX501 & PIX 506e

insccisco · ‎05-18-2006

can anyone help me in setup a VPN site-to-site connection between an office with a 506e and a remote office with a pix 501?

what are the commands that I should issue of both sides?

thanks

jmia · ‎05-18-2006

Here you go...

Please rate post if it helps, if you need further help let me know.

Jay

insccisco · ‎05-31-2006

Hi Jay, sorry for not getting back sooner. I have actually been working on this.

Besides your link, there is this one for an ASA

On both links, no where it says that I need to use the isakmp identity address command.

I had to call Cisco and the tech told me this. And even the links that he sent me later, none of them stated anything about this command.

Can you or anyone send me a link where all required commands will be listed???

thanks

jmia · ‎06-01-2006

Hi

As per the original document posted:

"The PIX uses the IP address method by default

for the IKE identity in the IKE negotiations"

isakmp identity address

Hope this clears things or need further help.

Jay

insccisco · ‎06-01-2006

Thank you very much Jay. It helped

jmia · ‎06-01-2006

Not a problem, glad to have helped. Please rate post so that it might help others too.

Thanks / Jay