We have recently installed a PIX 515 and using client 3.5.2 for remote users.
Our PIX has a VPN tunnel to our US office which works fine from the LAN, but I cannot see the US servers when I am offsite connecting using my VPN client. I can see the network, but not the US network.
Unfortunately, the pix does not do redirects. Once a client get in an interface, the packets that are going back out the same interface are only reply to the original source, it can not be to some other destination.
You need a router, if this is an important function for you.
Sorry for the misunderstanding. If the router was the vpn server, then you can do this functionalitry you are after,. If the pix is the vpn server, then unless the other tunnel is on a 3rd interface, you can not have this redirection.
So if the router you meant was behind the pix, you still have the problem.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...