VPN start to work after debug icmp trace and other things
I tried to add some more crypto lines to one of the pix's but if you don't add them in the proper order you can't access the pix any more. So first question what is the proper order ( I can't rember it I knewd it befor )After I rebooted the pix to go back to orginal config the vpn to an site stopped to work ( note I had no new lines in the pix )then I turned on icmp trace and then the vpn started to work! at another site it started to work when I turned on debug ipsec. Why is it so?
Re: VPN start to work after debug icmp trace and other things
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...