Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vpn / tunel problem, really need help!

I have a cisco827 and a 3005 concentrator. I have been trying to use the web based CRWS config tool on the router. When I click on "easyvpn" and fill out the first page I then go to the second page and get prompted for "username, password and domain". I have two blocks in which to enter the data but I am not sure what to enter or how to enter it. I am using nt domain authentication so I am assuming that I put in my domain account and password, if this is correct where do I put in the domain name? and how do I put it in? after the password using some special character I am thinking but at this time I am really needing some help. For what it is worth, I then go into the console port of the router and it is constanlty screaming for a username, password, and domain, again how do I enter it?

1 REPLY
Cisco Employee

Re: vpn / tunel problem, really need help!

If you've set up the 3005 to do NT authentication, and the 827 is asking for a password, all you should need to enter is the username and password, don't worry about the domain name.

On the 3005 you've specified the PDC/BDC to send the authentication request off to, and as long as your NT domain structure has the correct trust relationships, then your username/password should be authenticated successfully.

83
Views
0
Helpful
1
Replies
CreatePlease to create content