08-15-2006 11:05 PM - edited 02-21-2020 02:34 PM
Hi,
I should set up a VPN tunnel between a pix and a checkpoint NG ...
Problem: both sites use 172.16.x.x for IP-Range ...
Anyone knows where I can find some documentation or help on how to set-up this tunnel ?
P.S. As far as I could find something on the net, I have found some docu on checkpoint to configure a vpn with identical ranges on both sites, when using checkpoint on both sites ...
I need to find out how I can configure this on a PIX.
Thx a lot !!!!!
Karl
08-16-2006 12:41 AM
Following document describes communication between overlapping networks with PIX a and Concentrator
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtml
Both networks are 192.168.4.x and they are NATed to 20.1.1.0 and 10.1.1.0 and then encrypted
M.
Hope that helps rate if it does
08-17-2006 12:51 AM
It's not really what I was looking for, but this could help ....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: