I have network with 3 sites, each with Pix 501s. 2 of the sites have static IPs and I have an operational vpn tunnel operating between the two of them. The third site has a dhcp-assigned IP (cable internet) so I set up that Pix as a Easy VPN Remote Client in Network Extension mode and pointed it to one of the Pixs with a static IP. I used one of the configuration examples on Cisco's site (see http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008019e6d7.shtml) but I can't get it to work.
I have attached the related Pix configs; any feedback would be appreciated. Thanks!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...