02-24-2007 05:39 AM - edited 02-21-2020 02:53 PM
Hi,
One of our VPN tunnels stopped sending traffic.. IS there any way where we can reset the tunnel again since i know that there were no config changes done on the tunnel
Thx
Shyam
Solved! Go to Solution.
02-24-2007 05:44 AM
Hi Shyam,
To clear the tunnel, you can do a :
On PIX :
clear cry isa sa
clear cry ipsec sa
On IOS :
clear cry isa
clear cry sa
HTH,
Rate if this helped !
-Kanishka
02-24-2007 05:44 AM
Hi Shyam,
To clear the tunnel, you can do a :
On PIX :
clear cry isa sa
clear cry ipsec sa
On IOS :
clear cry isa
clear cry sa
HTH,
Rate if this helped !
-Kanishka
02-26-2007 01:17 AM
Hi,
Your answer is only applicable to a single tunnel. What if there are several tunnels and want to terminate specific tunnel w/o disturbing other live tunnels, is there any way we can point to specific SA id? or is it by way of clearing the specific vpn group? and what normally the time it takes to clear the SA id from the table and re-established the tunnel?
TIA
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide