Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN with NAT Static to dynamic an callback

I have the following problem:

we wont to build an VPN with Cisco 2651 Router and IPSec Software into the headquarter and 2621 Router with the same Software on the other sites.

We have an 128 kb leased line with an static IP Address in the headqurter and an ISDN Bri line with dynamic address on the other site.

The requirement of the network is, that the headquarter on must do the call on an seperatly Bri Port to the other side. The 2621er router must call the Internet and make also an tunnel to the headquater.

Can you help me to configure the routers? What do you wont to know about the network.

Thank you very much for your help.

Oliver Kutschenreuter

1 REPLY

Re: VPN with NAT Static to dynamic an callback

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

125
Views
0
Helpful
1
Replies
CreatePlease to create content