02-03-2003 05:32 AM - edited 02-21-2020 12:19 PM
Help!!
I am trying to configure VPN on my PIX 501. I have no experience of the PIX and have no idea where to start!
Any help will be greatly appreciated.
Thanks
Bennie
Solved! Go to Solution.
02-04-2003 05:19 AM
access-list
where
02-03-2003 07:54 PM
This is the best way to start configuring VPN on the PIX501
Cisco PIX Firewall and VPN Configuration Guide, Version 6.2
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_62/config/index.htm
Hope that helps,
Engel
02-04-2003 02:39 AM
The goalposts have moved slightly. The scenarion is this:
I have a Windows 2000 server that is running as a VPN Server. I have translated the public IP address to this PC via the PIX(I have tested this and I know it is working)
I know need to enable VPN traffic to pass through the PIX when it maps to one specific IP address. i cant find the port numbers that VPN uses
Any ideas??
Thanks
02-04-2003 04:21 AM
What protocol are you using? PPTP uses 1723 and the GRE Protocol.
02-04-2003 04:37 AM
I believe I am using PPTP. I have allowed tcp port 1723 inbound & outbound. (this is all of the security changes I have made!!)
Is there anything else I should do? The hitcnt on the accesslist does increase each time I try and access the VPN Server, but the client throws up an error "721 - the remote computer did not respond"
Any thoughts?
Thanks
02-04-2003 04:43 AM
you may have to allow the GRE protocol through also. The following line should allow it.
Access-list # permint gre any any
02-04-2003 04:49 AM
Pardon my ignorance! The command you have quoted does not appear to work :( . Is there a particular syntax I should use?
Thanks again for your help on this
02-04-2003 05:19 AM
access-list
where
02-04-2003 09:49 AM
This has worked!! Thanks for your help
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: