VPN & X-Applications

[dhopp]

I am using VPN and running Relection X as an emulator. I specify my assigned Client IP

address in Reflection, but when I try to launch

X applications from the HPUX host I get a display

not found error. I can ping the Client IP address

from the host. Can VPN block port 6000? Is there

anything else I check out?

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

[bill.barnes]

if you are running a vpn concentrator, you should check the filters and rules assigned to the filter which is associated with the private (inside) interface of the concentrator. if you don't have an any/any rule configured on this filter, you may have to create a custom rule allowing the appopriate ports for reflection to use.