Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN3005: can see GUI on private, not public

I have a new VPN 3005 running 4.0.4.a-k9. I have configured the public and private interfaces with IP addresses. However, I can only access the GUI with through the private interface. When attempting to access the public interface the web page does not load the GUI but says "Done" at the bottom. I have tried Firefox and IE but no luck either way with the public interface.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: VPN3005: can see GUI on private, not public

Hi Chris,

First of all we need to make sure that HTTPS access is allowed on the Public interface. For confirmation, please goto Configuration > Interfaces > Public > WebVPN and see if the 'Allow Management HTTPS sessions' is checked. You will also need to goto Administration > Certificate Management and make sure that the Public interface shows the correct IP and expiration under SSL certificates.

HTH.

Please rate if it is helpful.

Regards,

Kamal

2 REPLIES
Cisco Employee

Re: VPN3005: can see GUI on private, not public

Hi Chris,

First of all we need to make sure that HTTPS access is allowed on the Public interface. For confirmation, please goto Configuration > Interfaces > Public > WebVPN and see if the 'Allow Management HTTPS sessions' is checked. You will also need to goto Administration > Certificate Management and make sure that the Public interface shows the correct IP and expiration under SSL certificates.

HTH.

Please rate if it is helpful.

Regards,

Kamal

New Member

Re: VPN3005: can see GUI on private, not public

Kamal,

Thank you for your help. I did not need to mess with the certificates though.

100
Views
0
Helpful
2
Replies
CreatePlease login to create content