vpn3005 to router vpn hub-and-spoke problem

[knudsen-s]

Dear all.

I have a question and hope there is some who can answer this problem.

I have a VPN 3005 in a hub and spoke, where the vpn3005 is the hub. I have 4 sites that are conecting to the vpn 3005, that is working fine, but i can not comunicate between the spokes. I can comunicate with the central site from all but not between the spokes..

any andee ??

I have tryed to use the reverse route injection and network lists, but no go.

best regards

Soren Knudsen

skn@qualitynet.dk

[awaheed]

Hi,

I think we have a solution for you and its available on Cisco website at:

http://www.cisco.com/warp/public/471/vpn3k_lan2lan.html

Kindly configure your CVPN3000 accordingly and you should have what you want.

Thanks and Regards,

Aamir Waheed,

Cisco Systems, Inc.

CCIE#8933

-=-=-=-

[knudsen-s]

HI

Thanx for the replay. I have done most of it but it it not working, the only thing i have not done is the follwing... can that be the problem...

I have defined 0.0.0.0 as the local net, and i am not using any routing protocol like ospf.

best regards

[knudsen-s]

HI....

Thanx for the answer, it worked... thnax

best regards

Soren Knudsn