I'm trying to setup an IPSEC tunnel between a 3015 and 1600 router. The 1600 is configured with all the necessary commands and I can ping the two public address of each, yet the tunnel won't establish and I see no debug traces on the 1600 and nothing in the event log on the concentrator. The concentrator config should be ok, as when I hooked up a Vigor 2200 it "almost" setup the tunnel.
I have lifted the 1600 config from the : "Configuring L2L Tunnels on a VPN3000 conc with a Cisco IOS router".
Should I be able to do this, or will I have to use a 1700 series.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...