Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPNclient3.0 and split tunnel

We have configured a PIX (version 6.1)to take VPN tunnel connections from cisco secure vpn client v3.0

The vpn client dials into local ISP and then connects to PIX to establish a vpn tunnel. The local PC then gets an IP address from the pool configured on PIX. Now the VPN client is unable to access internet while the vpn tunnel is on. So I have added a command in the PIX for split tunnel. But the vpn client does not report that split tunnel is on. and

client is unable to access internet. Is split tunnel supported on vpn client3.0? any info is appreciated

1 REPLY
New Member

Re: VPNclient3.0 and split tunnel

Hi,

I have pix 6.1 and a remote vpn client 3.1, when I try to connect from remote network I am able to connect and I can ping outside interface of the pix but I can not ping inside interface of the pix.

any ideas..

Raul

85
Views
0
Helpful
1
Replies
CreatePlease to create content