VRRP stopped working after upgrading to v3.6.7F

[engel]

Hi,

Does anyone have issue with version 3.6.7F and VRRP setting ? It will not let an "IPSec over TCP" client to make a connection to a Master that was a Standby device.

Just want to verify if anyone else have the same issue.

Regards,

Engel

[engel]

Just taken a log from the client with IPSec over TCP enabled.

As you can see, there is no response from the Concentrator from port 10000. I think this is the evidence that the Concentrator doesn`t have a TCP/10000 opened.

1 20:40:18.515 05/12/03 Sev=Info/6 DIALER/0x63300002

Initiating connection.

2 20:40:19.216 05/12/03 Sev=Info/6 IPSEC/0x6370001F

TCP SYN sent to 10.10.10.2, src port 2985, dst port 10000

3 20:40:24.223 05/12/03 Sev=Info/6 IPSEC/0x6370001F

TCP SYN sent to 10.10.10.2, src port 2985, dst port 10000

4 20:40:29.231 05/12/03 Sev=Info/6 IPSEC/0x6370001F

TCP SYN sent to 10.10.10.2, src port 2985, dst port 10000

5 20:40:34.238 05/12/03 Sev=Info/6 IPSEC/0x6370001F

TCP SYN sent to 10.10.10.2, src port 2985, dst port 10000

6 20:40:38.594 05/12/03 Sev=Warning/3 DIALER/0xE3300008

GI VPNStart callback failed "CM_CTCP_FAIL" (1Dh).

7 20:40:39.605 05/12/03 Sev=Info/6 IPSEC/0x63700022

TCP RST sent to 10.10.10.2, src port 2985, dst port 10000

8 20:40:39.605 05/12/03 Sev=Info/4 IPSEC/0x63700014

Deleted all keys

[engel]

Hi All,

Does anyone experience the same issue with VRRP+ IPSec over TCP using version 3.6.7F ?