I have a 3002HW client at a remote site the only way that the tunnel comes up is if the 3002 initiates the traffic. ie I cant ping the remote site from the host site. then after I ping the host site from the remote site I can ping both ways. Is this normal behavior. Is there anyway i can change this?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...