What is ASDM username/password

[Phil Williamson]

I've setup basic config on ASA5510 running asa721-k8 and asdm521 via CLI. Now when I access via ASDM the username/password does not work. Any suggestions? I can access via console, telenet and SSH with no problems.

[Fernando_Meza]

Hi .. try leaving both entries blank ..

[victorrodrigues]

Hi

i think ur looking at it all wrong.. what exactly is the error when u use the asdm.. i guess it just does not let u in..

look at the bottom of the page that is tryin to load the page.. it will read " java security .... (something).. access denied..."

this is due to ur version of java... make sure u have atleast java 1.4.2 upward and try again.. 1.5 works fine.. the problem is that if u go back to access and old pix device.. it will not support 1.4.2 and above.. so that is a more frequent issue..

I hope it helps .. please rate it if it does !!!

Victor

[Phil Williamson]

I found the problem. I had upgraded ASDM version and forgot to tell ASA about it. Now works with my username/password.

[victorrodrigues]

so.. how did u tell the ASA about it ?

[Phil Williamson]

asdm image disk0:/asdm521.bin