I've setup basic config on ASA5510 running asa721-k8 and asdm521 via CLI. Now when I access via ASDM the username/password does not work. Any suggestions? I can access via console, telenet and SSH with no problems.
i think ur looking at it all wrong.. what exactly is the error when u use the asdm.. i guess it just does not let u in..
look at the bottom of the page that is tryin to load the page.. it will read " java security .... (something).. access denied..."
this is due to ur version of java... make sure u have atleast java 1.4.2 upward and try again.. 1.5 works fine.. the problem is that if u go back to access and old pix device.. it will not support 1.4.2 and above.. so that is a more frequent issue..
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...